-
Modelers Alliance has updated the forum software on our website. We have migrated all post, content and user accounts but we could not migrate the passwords.
This requires that you manually reset your password.
Please click here, http://modelersalliance.org/forums/login to go to logon page and use the "Forgot your Password" option.
Junkers Ju87D "Stuka" 1/32
- Thread starter Bagge
- Start date
jknaus
Administrator
Looking good Matts. Depending on when in the war this a/c is from the siren was removed. After a while it no longer gave the psychological terror it had at first and they got a few mph back by removing the props which caused some drag. Thats as far as I know from my reading.
James
James
Bagge
Well-known member
Did some painting today, with mixed success :tomato
Pre-shade on the SC1000 bomb
Topcoat on
Propeller
The top of the propeller is yellow and that's where i was not so successful, i primed it again (just the top) and then tried to mask off the top
and then the yellow paint was to thin :vmad
Did some mixes and i think they are good enough for me
See if i can save the prop or if i repaint it....
//Mats
Pre-shade on the SC1000 bomb
Topcoat on
Propeller
The top of the propeller is yellow and that's where i was not so successful, i primed it again (just the top) and then tried to mask off the top
and then the yellow paint was to thin :vmad Did some mixes and i think they are good enough for me
See if i can save the prop or if i repaint it....
//Mats
Bomb looks good Mats, I have never been able to preshade, I always layer too much on the top coat.
On the prop, would you have a hard demark between the colors?
On the prop, would you have a hard demark between the colors?
Bagge
Well-known member
yes it's a sharp edge between the ral70 and the yellow, i found another can with yellow and filled in with a brush, it looks ok, i see if i can do some wash ontop of it (it's spinning so maybe i can pull off something 
It was difficult to make the maskingtape follow around the conical spinner, think i should have painted the yellow first.... must remember that to next time
It was difficult to make the maskingtape follow around the conical spinner, think i should have painted the yellow first.... must remember that to next time
White_Wolf
Master at Arms
Looking good Mats, that prop reminds me of the caramelised sugar my nan used to make sometimes - SWEET !!!
Laurence
Laurence
Oh on the spinner! Ok. 
Wish I could help Mats :zen
Old Dog
Well-known member
Not sure if the SC1000 is the same as the SC500 but I ran into a similar quandary on my Condor, I added two bombs from a Hasegawa ordinance set and it showed two stencils going around what appeared to be the filler plugs on the bomb body and when loaded on the plane they would be on the top of the bomb where they can't be seen. Only useful if you are displaying the bomb separately or on a bomb loader.
They were meant for the armorers to see...
You may want this manual:
http://www.ibiblio.org/hyperwar/USA/ref/TM/pdfs/TM9-1985-2-German.pdf
Regards,
