Jenny Croft
Banned
This is a really good tip if you are working with small photoetch parts , nothing is worse than cutting off that vital PE part & ping :evil: the carpet monster will find it !
You will find it 3 months later while searching for another stray PE piece !
Use the wide Tamiya tape & tape across the back ( side without the part numbers ) of all frets in the set , then the whole fret does not go astray either
. Then with a sharp knife , cut all bits required for the assembly sequence you are working on . Only pull them off the tape as needed
Jenny
You will find it 3 months later while searching for another stray PE piece !
Use the wide Tamiya tape & tape across the back ( side without the part numbers ) of all frets in the set , then the whole fret does not go astray either
. Then with a sharp knife , cut all bits required for the assembly sequence you are working on . Only pull them off the tape as needed Jenny
