Re: 1/16 Ardennes Tank Riders...Update 09/15/12
Update Pt. I - Boring Stuff
I figured I had better blank off the back side of this thing and work out some sort of way
to mount it before I got too far along...
0.040 sheet added to hull:
The same added to turret:
It would have been near impossible for this to be in one piece, as my cuts are not perfectly square and
aligned, so the turret sticks out a bit...but I think it kinda looks cool that way:
I built a stand out of styrene sheet and tube:
And corresponding tubes underneath the hull:
This will hold it for working on the bench, will probably do some sort of brass tube inserted into a
wood base for final display...but that's later.
Update Pt. II - More Interesting Stuff
Needed to add some lift lugs around the engine fans:
At first I figured they were simply spaced 90 deg. around the fan, but no, they are at all kinds of
weird angles. This also shows some work done to make the engine cove appear to be a separate peice:
Finally glued on the hull rear plate:
Needed to cut the exhaust covers to the proper angle...note the high-tec marking device:
Here I'm adding the blocks that mount the fenders:
I made a jig for drilling out the tow cable/cleaning rod brackets. Drill hole, insert spacer,
drill hole and so on...worked pretty good, and I made extras just in case:
All the brackets drilled:
One bracket completed:
And the full set:
Brackets glued in place and welds added:
A little close-up:
Welds added to rear plate:
Here's a mock up, with some parts just sitting there, not glued yet. I think I'm about ready
to start adding some PE to the hull...I haven't really done much work to the turret yet.
Thanks for looking, all comments, critiques welcome!!
Tom