I have a figure I bought recently off of Etsy. It was a 12k print that was hollow with internal supports which really surprised me. Made the 1:6 scale figure quite light. Most of the parts like the legs were super smooth, Other parts like the boots and head had very, very small raster which could be seen only with magnification. Very nice figure and once the joining areas are cleaned up it should fit together perfectly. I am looking at the Elegoo Saturn 3 Ultra, but at this point am watching my cash flow so no printer yet. If they are coming out with a Saturn 4 soon, I might just wait a little longer.
Watched a video on the Saturn 3 Ultra and the prints looked amazing. As it is a 12k, the raster on the prints was almost invisible. Yeah it is at the $500 mark, but compared to what resin printers cost even a few years ago that is quite cheap. (yay!) I recently bought a watchmaker tool, a press to close stubborn watch cases and it was more than the printer. So I am going to be patient just a little bit longer.