Sherman in 1/16 scale.

[Heavens Eagle]

Unlike some folks, when I post on his threads he usually posts back. As I said, I am trying to get him to post here. I think if he just once joined in he would enjoy the group we have here a lot, especially with the talented folks here.
Hope you didn't mind my doing a slight hihack on your thread Tim. His work is well worth looking at for the detail and how it looks.

 

[Tim A.]

Unlike some folks, when I post on his threads he usually posts back. As I said, I am trying to get him to post here. I think if he just once joined in he would enjoy the group we have here a lot, especially with the talented folks here.
Hope you didn't mind my doing a slight hihack on your thread Tim. His work is well worth looking at for the detail and how it looks.

I admire his work. And as you said, is good about replying and answering questions people have.
With my stupid machine guns problem for the Sherman I contacted him about a solution to the open ammo boxes and he got back to me quick with a solution.

 

[Tim A.]

It was going to push close to a Benjamin bill to replace the 30 & 50 cal machine guns with aftermarket ones after shipping.
So I'm going a different route. I've ordered an Aber brass barrel for the 30 cal. I also ordered 50 cal and 30 cal open ammo boxes from Steel Pot Studios, high quality state side offerings.

Some more details from Steel Pot for the Sherman came today.

 

[Tim A.]

Went ahead and ordered the Aber 50 cal barrel upgrade as well.

I may have to get a job...I swear the next build is going to be STRAIGHT OUT OF THE BOX.

 

[Heavens Eagle]

Have one and am looking forward to starting my Soc Sec. which I hope is enough to start doing massive pay down on this house. Not sure how much it will be and not sure how taxes will hit me, but it will be a wait and see.