Free Files

[HDSDesigns]

I offer some of my designs on Cults3D for free. This is a great way to get started in 3D printing if you have just purchased a 3D printer and are a little reluctant to purchase some 3D files until you get some experience under your belt!
https://cults3d.com/:1467637

 

[jknaus]

I've got a few of your files. They're very very nice. Printing out the Dragon Wagon as I have time.
James

 

[Sharkmouth]

@HDSDesigns, hey! I know you. Introduce yourself as a modeler.

 

[moon puppy]

Neat looking stuff. Yeah hows about an introduction?

Introduction Forum

If you are new here, pop in here & introduce yourself to all the gang!

modelersalliance.org

 

[HDSDesigns]

I've got a few of your files. They're very very nice. Printing out the Dragon Wagon as I have time.
James

Thanks, that conversion set was a long protracted project that went back years. I lucked out and located an actual vehicle close to where I live to take measurements from.
It sat on a “digital” shelf for years because I couldn’t figure out how to make the corners come together on the cab.
It’s two curved corners that meet a cone and create a semi-sphere and drove me crazy trying to figure it out!
I stopped working on it for a couple of years and then one night it came me into a dream how to do it and it actually worked!

 

[Sharkmouth]

Mike (@HDSDesigns), I won't out your full name, just hoping if the idler files are sharp enough to get the casting codes better. Loved them anyway!

 

[HDSDesigns]

I think that is the other Mike. I never did an idler wheel.

 

[HDSDesigns]

I think that is the other Mike. I never did an idler wheel.

 

[Sharkmouth]

I think that is the other Mike. I never did an idler wheel.

It was a 50/50 chance, Mike, and I blew it!