Hex stock?

[Sherman 18]

Does anyone have a source for "hex" stock in the US? I've heard and read about it but have never seen in person.

 

[Sharkmouth]

Are you asking about hexagonal styrene rod as made by Plastruct?



Regards,

 

[moon puppy]

Plastruct has it for sure, I have it in my stock.

 

[Adam Baker]

Yup, definitely Plastruct, I have 3 or 4 sizes in my stash as well.

Been trying to find small diameter aluminum hex, but havent been able to find anything smaller than .125".

 

[phantom II]

Try this Adam . http://www.onlinemetals.com/merchant.cfm?id=81&step=2

Cheers, Christian B)

 

[Sherman 18]

Are you asking about hexagonal styrene rod as made by Plastruct?



Regards,

yep that is it

 

[Sharkmouth]

Are you asking about hexagonal styrene rod as made by Plastruct?



Regards,

yep that is it

Then click the image and go shopping! Don't overlook the other shapes too. The triangular ones are good for the stiffeners on the bottom of Shermans, check underneath yourself!

Regards,

 

[jknaus]

Try this Adam . http://www.onlinemetals.com/merchant.cfm?id=81&step=2

Cheers, Christian B)

Ooohhhh shinies
Thanks Chris, bookmarked.
James

 

[jknaus]

Are you asking about hexagonal styrene rod as made by Plastruct?



Regards,

Thanks Saul, bookmarked.
James

 

[Sherman 18]

Thanks Saul!

 

[Adam Baker]

Yea, thats one of the sites I've seen in the past, but unfortunately they dont go smaller than .125". I'm wanting to make my own fittings for my race car models, so I'm going to need like .030" and larger for what I'm wanting. If/when I'm finally able to do it, chances are I'll just have to machine my own from either square or round stock to get what I want.

Try this Adam . http://www.onlinemetals.com/merchant.cfm?id=81&step=2

Cheers, Christian B)