Search results

Tony! Tony! Tony! See what I did there?...

That is a great looking plane! I have never seen a plane like that one 🤔 Very cool!

You've been busy! It all looks great :tens:

If that is all it takes I am stopping caffeine immediately!

I am shocked!...NOT!! Well deserved sir. Congrats again.

How? How is that even possible? Mouth. Dropped. :notworthy

One of the best weathering jobs I have ever seen! Super well done 🤩 Congratulations!

I just ordered a tiny heated vacuum press and plastuc film to see if I can make new windows for the Camaro. It's always something, right? Thanks for holding me up guys. @Rhino, I think (I hope!) the wood will be fun and therapeutic. Thank you though! :Drinks:

The engine for the Camaro was fun. However, comma & exclamation point...I stepped on the clear windshield parts. I need to order a vacuum and form new windshields.

Dang, look at that engine! So good 🙂

I gotta say that thing was difficult to print. Everything is so thin! But it is looking great! I am glad you are a skilled builder to pick up my slack LOL.

Update on this build and me in general. I never found the missing sprues. I have another kit on backorder because I DO want to finish this. I started @Rhino 's Coast Guard cutter but during our 7-10 degrees and 4 days no power fest the resin warped from the cold. Newly cast parts coming for...

:popcorn that turret to tank comparison is an eye op'ner fəh'sher!

Fill, sand, mark, cuss, repeat ...excellent!

One of the coolest dio's ever!

I know a nice figure when I see one. These are superb!

Well, turns out I have mommy babysitting duties for the day. 🫩

We were prepared with a generator to run the fridge and water pump and one light. We had plenty of food and our stove is gas so we could cook. It was kind of like glamping I guess...

Don't know why I don't get alerts. We had lots of ice and lost power for 4 days. The following weekend we got 5 inches of snow and didn't lose piwer.

In blender I just select what I want to be higher or lower and move it on the Z axis accordingly. I got rid of the framework then traced around the main image then deleted everything not needed (the flat area around the relief); then selected the surrounding edges of the relief and extruded...