Le2
Member
Well new project for 2016 The vehicle is just mounted. Then I'll try to give a new start.
As the model was partially mounted the first step is to remove all plastic parts which will then be replaced by PE parts.
This work is done on both sides and at the top of the superstructure of the tank.
Dogfish have adapted to different types of forms facilitates work in hard to reach areas.
With the back of an edge remove some surplus from previous adhesives that have been left on the model.
It is important to always place the blade horizontally to the surface to work and not to press too.
Using a knife we emphasize some sectors.
Then the work is softened with a light coat of glue.
Much work in the first stage of the front of the vehicle.
Handles corresponding to a PZIV H were incorrect in this model 3 rollers.
They were removed from the front plate and replaced by other generated scratch.
plastic fenders were also cut and replaced by fotograbados between
other initial details have been added.
Thanks for watch!
As the model was partially mounted the first step is to remove all plastic parts which will then be replaced by PE parts.
This work is done on both sides and at the top of the superstructure of the tank.
Dogfish have adapted to different types of forms facilitates work in hard to reach areas.
With the back of an edge remove some surplus from previous adhesives that have been left on the model.
It is important to always place the blade horizontally to the surface to work and not to press too.
Using a knife we emphasize some sectors.
Then the work is softened with a light coat of glue.
Much work in the first stage of the front of the vehicle.
Handles corresponding to a PZIV H were incorrect in this model 3 rollers.
They were removed from the front plate and replaced by other generated scratch.
plastic fenders were also cut and replaced by fotograbados between
other initial details have been added.
Thanks for watch!
....
